Telcoma OC2 Serie Manuel D'utilisation Et De Programmation page 25

REMOTE SELF-LEARNING (for the FM400 series only)
The FM 400 series gives the possibility of memorizing remote controls directly in
the receiver without having to manually operate it as described in the previous
chapter.
To do so it is necessary to have at least a functioning 4 channels remote control
which has already been memorized in the receiver using the procedure described
above.
The operations described below must be carried out observing the times
specified.
1 – Press together all 4 buttons of the already memorized remote control, for at
least 3 seconds.
2 – Release the C5 button and within 2 seconds press shortly, on the same
remote control, the button which is already memorized in the receiver (example:
C1)
3 – Within 2 seconds press the button on the remote control which has to be
memorized in the receiver.
If necessary repeat the procedure also for the other buttons.
On the receiver it is also possible to disable the remote programming function by
closing the JP1 jumper (fig. 1).
HOW TO DELETE CODES
1. How to delete a code.
With this operation one or more codes may be deleted from the receiver memory.
- During the programming stage, press the P button 4 times.
- The LED corresponding to the button will emit 5 series of 4 blinks.
- During this stage transmit using the remote control that has to be deleted.
The LED will light up steadily for a few seconds indicating that the delete procedure
has been successfully completed.
2. How to delete all codes (reset)
If the device is reset, the receiver memory is deleted entirely.
- Keep the P1 button in fig.1 pressed for at least 10 seconds until the LEDs of both
buttons light up simultaneously. After a few seconds the LEDs will go off, indicating
that the delete procedure has been successfully completed.
- Repeat the learning procedure.
GB
25