Radio Operation - Salora CR 612 Mode D'emploi

6

Radio Operation

Listen to the Radio
1. Press POWER (1) button to turn on the radio. The current radio
frequency appears on the display.
The radio is default to FM mode at frequency 87.5
(MHz), and at 522 kHz for AM mode, or the
frequency of last station listened will be displayed.
Press BAND (11) button to select the band.
2.
3. Automatic tuning - Press and hold TUNING
(7) button for 2 seconds until the frequency displayed move up or down.
Release the button. The tuner will scan and stop for the first strong
station. Repeat until the desired station is reached.
4. Manual fine-tuning - Press TUNING
button repeatedly to adjust the frequency by each step.
Volume Control
Press the VOLUME (3) or VOLUME
level.
Achieve Optimum Reception
FM : Extend the FM wire antenna fully to increase reception sensitivity.
AM : Rotate the unit horizontally to the position in which reception is clearest.
Program Preset Radio Stations
You can store up to 10 preset stations each for FM and AM band.
1. Tune in the station you want to preset.
2. Press and hold SET (9) button for 2 seconds until
program number blink. Press the SET (9) button
again to store the station.
3. Repeat these steps to store additional stations.
Recall Preset Radio Station
In radio mode, press the MEM (12) button repeatedly to the program number
of which the desired station is stored.
EN
(6) button or TUNING
(6) button or TUNING (7)
(4) button to adjust the volume
5