Helpful Tips - Igloo IWCBL353CRHBKS Instructions Et Recettes

1. Place bottle, glass, or pitcher below the cold water tap.
2. Push the cold/room temperature water button downward to start dispensing water.
3. Release the button once the desired fill
level is achieved.
Dispensing Hot Water
After setup, it will not take long to reach maximum hottest
temperature. When it reaches hottest temperature, the red light will
turn off. NOTE: For safety, there is a lock on the dispensing button.
1. Place bottle, glass, pitcher, pot below the hot water tap.
2. Release child-safety lock by sliding the red button
and push the hot water button downward at
the same time to start dispensing water.
3. Release the button once desired fill level is achieved.
NOTE: Be careful when dispensing hot water as temperature can reach 200 °F.
Replacing An Empty Bottle/Low Water Indicator lights
Replace the bottle as soon as you notice that it is empty. The
LOW WATER INDICATOR LIGHTS will help you.
• When the water tank is over flowing, the water shortage
indicator light is off and alarms for one minute
• When there is no water in the water shortage tank, water shortage indicator light flickers
• When there is water in storage tank but no water in bottle, the water
shortage Indicator light in on & will alarm for 30 seconds
• When the water tank and bottle are both low on water, the whole machine is
locked, the water shortage indicator light flickers and alarms for 30 seconds
• When opening the door, the pump stops working. If the water level in the cold
tank is higher than the water control level, the machine will still work normally

HELPFUL TIPS

DISPENSER IS NOT WORKING
• Make sure that the power cord is properly connected to a working outlet.
WATER IS LEAKING
• Replace water bottle. Most common cause is a cracked bottle.
NO WATER IS COMING OUT
• Make sure bottle is not empty. If so, replace it.
• Make sure that you fully press the water control buttons.
WATER DISPENSER IS NOT COLD
• Make sure cold switch is ON. Switch is located in the back of the water cooler.
• It can take up to six hours after setup to dispense coldest water.
• Make sure back of the dispenser is at least 4 inches from a wall
8