Installation In The Vehicle - MS BS07-TT Manuel D'instructions

Installation in the vehicle

4.1.2. Installation of Group I and it is for the children
whose weight between 9-18kg. (BS07-TTB)
• Adjust the baby car seat into the sleeping position ( 3-C ).
• Take the Lower Shaft out of the seat, then pull the seat back ( 4-A ).
• Install the safety belt through the seat back from the middle of top and fixed
it into the buckle on the car seat ( 4-B ).
• Open the Lock-off device and Belt tension part ( 4-C )
• Put the belt through the Lock-off device / Hooks and Belt tension part, clo-
sed the Lock-off device and Belt tension part. Tighten up the belt, fixed it
into the buckle on the car seat ( 4-D ).
• The seat will be fixed by two belt in two directions. One belt from the Lock-
off device of the seat and the other from the Hooks for lap belt, tighten car
belt, use Lock-off device to clip it. So it can not move ( 4-E ).
• Make sure the axis exactly fit into the groove and you can heard click sound
( 4-F ).
• Put the seat body back to its Lower shaft and lock the shaft safety ( 4-G ).
• Pull out a small portion of the Upper metal shaft, let the shoulder belt go
through inside of the Upper metal shaft ( 4-H ) and secure the Upper metal
shaft ( 4-I ).
Please make sure that any lap strap is worn low down, so
!
that the pelvis is firmly engaged.
17