Eiko DTD-2C-50K-U Instructions D'installation

SAFETY PRECAUTION:
IMPORTANT: READ INSTUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
• Disconnect power before installing or servicing.
• Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety.
• THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPICABLE INSTALLATION CODE BY A
QUALIFIED ELECTRICIAN WHO IS FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
HAZARDS INVOLVED.
• This fixture is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK
SUITABLE FOR DAMP LOCATIONS USE
INSTALLATION:
ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
MOUNTING DIRECTLY TO SURFACE
1. Do not remove any part of the fixture.
2. The label on the fixture shows the specification.
3. Use expansion bolts to secure the fixture on
mounting surface. (See Fig. 1 & Fig. 2)
4. Keep enough length of wires to ensure that the
adjusting angle is unhindered.
5. Connect wires into wiring terminal; white wire to
"Neutral" terminal, black wire to "Line" terminal,
green wire to "Ground" terminal; and secure
them with screws.
6. Please note the input voltage before wiring.
1
Wire Connector
L (Black)
G (Green)
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
Rev. 1/25/2017
2
N (White)
INSTALLATION INSTRUCTIONS
MOUNTING TO SURFACE WITH AN ARM
1. Connect wires of the same color (corresponding to wire N, L
and G) together with a wire connector.
2. Put one end of the arm into the U-slot of the fixture, and then
secure the arm into the fixture with two hex socket screws.
Please make sure that the fixture will not rotate on the arm.
(See Fig. 3)
3. Secure the wall clamp on the arm in the desired position and
make sure that the arm will not rotate.
4. Secure the arm to the wall with four screws.
DTD-2C-50K-U
LED Dusk to Dawn
3
G (Green) N (White)
L (Black)