Publicité
LAPPSET
Please note! In the absence of sufficient installation staff you may need to use a crane to
attach the Tube slide to a tall structure.
1. Use the parts list and the markings on the components to make sure that you have all of
the necessary parts.
2. Choose a location for the product, taking into account the safety margins specified in the
mounting instructions: leave 2 metres in front of the slide's end and 1 metre on both
sides. The curve of the Tube slide must correspond to a total fall height of 1 metre.
Prepare the ground for anchoring the end piece.
3. Assemble the tubular components in accordance with the instructions on pages 4 and 5,
taking into account the positioning of transparent elements.
4. Join the components together following the numbering in the instructions. An example of
how to assemble the tube is shown on page 6. Make sure that none of the transparent
elements are used for the sliding surface.
5. Pre-assemble the top deck and position it at the upper end of the slide as shown in the
instructions. Fix the steel anchors on the bottom of the slide (part No 905850) into place
as instructed and attach to the bottom end of the tube.
6. Lift the tube up against the structure and fix into place using the mountings provided. Fill
the area in front of and underneath the slide with sand.
7. Follow the instructions in the supplement to mount support posts if required.
8. Inspect the installation thoroughly using the checklist provided. Document the completed
checklist carefully. Remember to stop children from using the product until it has been
fully built and safety-tested and all mounting equipment has been cleared away.
TUBE
REF:
DATE:
28.4.2008
2
Publicité
