Table des Matières
Publicité
TOOLS
Please take the time to read these operating instructions before use and retain them for future
reference. Failure to follow these instruc tions may lead to serious personal injury and damage to
property.
1 Safety instructions
WARNING!
Keep the cleaner away from children!
This device is not intended to use by individuals with restricted phys ical, sensory or mental
capacities or those with lack of experience or knowledge, including children, unless they are
supervised by an individu al who is responsible for their safety or have received training in
operating the device.
Please read the following very carefully as failure to comply may invali date your guarantee.
•
Do not run the cleaner continuously for more than one hour at a time, as doing so can damage the internal components.
•
Do not operate the unit without fluid in the tank. Always ensure the fluid is no higher than the maximum mark. Always
ensure there is a minimum depth of 7 cm.
•
Do not drop any item into the tank as this may cause damage to the transducer. Always use a basket and place the items
gently into the tank.
•
The more items that you place in your cleaning bath the less ef ficient it will clean. It is not advised to overlap items. Always
allow plenty of clear space between the items.
•
Do keep the lid on during use. This will prevent splashes and re duce evaporation of the fluid.
•
Never immerse the machine or power cord in water or other liquid.
•
Do not touch the power plug with wet hands, especially when inserting or removing the plug.
•
Do not touch the unit if the machine has fallen into water during operation. Remove the power plug from the socket first.
•
Do not disassemble the machine.
•
Unplug the power source while filling or emptying the tank.
•
Do not spray water or liquid over the device or control panel.
•
Do not operate the cleaner without proper grounding.
•
Do not place the device on a soft surface, where the vents could be blocked.
•
Always turn the heater off after using as leaving it on can cause the fluid to evaporate and damage the internal
components.
•
Upon completion of the cleaning cycle, turn the heater button off and isolate the machine from the electrical supply.
•
Take care when adding or removing items from the cleaning tank as the fluid is likely to be hot and displaced fluid can
damage the inter nal components. Any displaced fluid must be dried up immediately.
•
In the event of failure/emergency, disconnect the mains supply by removing the plug from the mains socket.
2 Description
•
Stainless steel housing, tank and lid.
•
Stamp tank without welding gap for better waterproof.
•
Drainage and cool fan.
•
Moisture-proof PCB.
•
Industrial grade IC and ultrasonic transducer.
8
M1.1.UCC.NLFREN - 12032018
EN
Publicité
Table des Matières
