Technical Parameters - MW TOOLS MV500LV Mode D'emploi

1 Caution
• Please cut off the power when you move the exhaust fan. Don't pull the electrical wire emphatically.
• Don't touch the blades by hand or something hard before the fan stops.
• Use professional tools for disassembly when the fan need repaired. It must be repaired by an expert and changed in the
appointed place by the manufactory.
• The exhaust fan is not suitable for use in the caustic and volatile environment.
• This product is only used indoor.
• Do not let children or infirm persons use the appliance without supervision.
• Ensure that the fan is switched off from the supply mains before any cleaning.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified in order to
avoid a hazard.

2 Technical parameters

Model
Voltage
Power
Frequency
Diameter
Air flow
Speed
Working temperature
Net weight
Dimensions (l x w x h)
3 Installation
Place the ventilator on flat, horizontal surface.
4 Operation
To start the fan:
1. Be sure the power switch is in the OFF position.
2. Connect to an approved power source.
3. Make sure area is clear from all obstructions.
4. Push power switch to the LOW position and allow to operate for 10 seconds.
5. Once 10 seconds have passed, you may now push the power switch to the HIGH position.
To turn off the fan:
1. To turn off the fan, simply return power switch to the OFF position.
Note: For longer parts life, after 10 hours of continuous operation, turn the fan off for 15 minutes to
allow motor and fan belt to cool.
MV500LV
230 V
150 W
50 Hz
500 mm
100 / 115 / 120 m³/min
800 / 920 / 1050 rpm
-20 - +80 °C
6,5 kg
620 x 260 x 610 mm
4
M1.3.MV500LV.NLFREN 07092018
EN