JL Audio DOMINION d108 Mode D'emploi page 19

SYSTEM CONNECTION DIAGRAM 2:
Multiple Dominion™ Subwoofers
to Home Theater Receiver or Home
Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer line-level output.
When connecting a mono subwoofer
output to more than one Dominion™,
use a Y-adaptor cable (splitter) to split
the output signal to multiple audio
interconnect cables, each feeding a
separate Dominion™ subwoofer. Use a
good-quality audio interconnect cable
with RCA-type connectors.
In most cases, you will use
the bass management/crossover
features of the receiver or preamp/
processor. This requires that the "LP
Filter" switch of your Dominion™
is placed in the "Off" position.
Some receivers and preamp/
processors offer multiple subwoofer
outputs, which can be used to connect
multiple Dominion™ subwoofers.
Refer to the manual of your
receiver/pre-pro for details.
WARNING
| d108 & d110
RECEIVER / PROCESSOR
PRE OUT
FRONT L REAR CENTER
FRONT R REAR SUB
Y-ADAPTOR
WARNING! TURN OFF THE DOMINION™(s) AND ALL OTHER EQUIPMENT
IN THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
LP Filter
off | on
DOMINION™ REAR PANEL (#1)
LP Filter
off | on
DOMINION™ REAR PANEL (#2)
Page 19