ASROCK 4Core1333-GLAN Guide D'utilisation page 15

Table des Matières

Les langues disponibles

2.5 Jumpers Setup

The illustration shows how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is "Short". If no jumper cap

is placed on pins, the jumper is "Open". The

illustration shows a 3-pin jumper whose pin1

and pin2 are "Short" when jumper cap is

placed on these 2 pins.

Jumper

PS2_USB_PWR1

(see p.2 No. 1)

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power supply.

Clear CMOS

(CLRCMOS1, 2-pin jumper)

(see p.2 No. 10)

Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system

setup parameters. To clear and reset the system parameters to default setup,

please turn off the computer and unplug the power cord from the power

supply. After waiting for 15 seconds, use a jumper cap to short 2 pins on

CLRCMOS1 for 5 seconds.

ASRock 4Core1333-GLAN Motherboard

Short

Setting

Short pin2, pin3 to enable

+5VSB (standby) for PS/2

or USB wake up events.

2-pin jumper

Open

Description

1 5

Table des Matières