Taurus Alpatec LANDSCAPES Mode D'emploi page 8

INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Respect the legal provisions concerning safety
distances from other elements such as pipes,
electrical connections, etc.
- Ensure that the appliance is level with respect
to the floor.
- The appliance requires suitable ventilation in
order to work properly. Leave a space of 150
cm between walls or other obstacles..
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has
been removed.
- To eliminate the smell given off by the applian-
ce when used for the first time, it is recommen-
ded to have it on at full power for 2 hours in a
well-ventilated room.
- Prepare the appliance according to the function
you wish to use:
INSTALLING THE PRODUCT
- Pull the rear cover handle to remove it (FIG1)
- Remove the plastic package from the filter.
(FIG2)
- Install the filter into the machine (FIG3)
- Fasten up the rear cover and connect to the
power source (FIG4)
USE:
- The appliance can be used directly connected
to the mains.
- Extend the cable completely before plugging
it in.
- Attach the appliance to its base / connector
making sure that it is correctly fitted into place.
- Attach the appliance to its base making sure
that it is correctly fitted into place.
- Ensure that the electronic connector is properly
attached to the appliance.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by using the on/off
button.
- Turn the appliance on, by using one of the
speed selection buttons.
- The pilot light (4) comes on.
- Select the desired speed.
TIMER FUNCTION:
- The appliance's operating time can be control-
led.
- To program the operating time simply select it
using the (8) buttons.
FILTER REPLACEMENT
- When the filter life expires (about 3000 hours
of life time) the filter replacement indicator will
blink blue to remind you.
- Follow "installing the product" instructions
- After change the new filter, press and hold for 5
seconds to reset.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the
speed control.
- Turn the appliance off, using the on/off button.
- Unplug the appliance from the mains.
- Clean the appliance.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.