AEI Security & Communications DigiSender ZX7 Mode D'emploi page 12

ENGLISH (EN)
DG458 - DigiSender® ZX7 - Quad Input 5.8GHz Wireless AV Sender
Using the DigiSender® ZX7
Advanced Functions
Changing the Audio/Video Channel
The DigiSender® ZX7 features 4 Audio/Video Channels. Each of these Audio/Video Channels slightly
changes the frequency on which the DigiSender® ZX7 operates. Because the Audio/Video Channel
switch allows you to 'fine tune' the frequency on which your DigiSender® ZX7 operates, it is possible
to overcome most interference and reception troubles that may occur.
To change the Audio/Video Channel on your DigiSender® ZX7, simply change the position of the
Audio/Video Channel switches to match below.
CHANNEL 1 CHANNEL 2 CHANNEL 3 CHANNEL 4
For your DigiSender® ZX7 to function correctly it is very important that the Audio/Video Channel
settings are the same on both the Transmitter and Receiver and that only 1 switch is down at
any time.
Changing the Remote Relay Channel
The DigiSender® ZX7 combines our advanced DigiEye™ technology with the IR Systeme Technik™
Remote Relay kit and features 16 digital Remote Relay Channels.
To change the Remote Relay Channel on your DigiSender® ZX7, simply change the position of the
Remote Relay Channel switches. Any combination of up and down switches can be used.
For your DigiSender® ZX7 to function correctly it is very important that the Remote Relay Channel
settings are the same on both the Transmitter and Receiver.
Page 12 Please read this instruction manual carefully prior to installation