Base Assembly - Outdoor Leisure TD100 Manuel D'utilisation

ASSEMbLy
Estimated assembly time: 45 minutes
Tools required:
• # Phillips screwdriver
• 9/16" and 5/16" Open end wrenches
Hardware packet provided with heater may
contain more parts than needed for heater
assembly. Parts are referenced by designated
letter throughout assembly instructions. Hard-
ware packet contains the following (quantity
used in parenthesis):
Description
A 1 / " Screw (8)
1

B 7 mm Washer (8)
C 5/8" Screw (9)
D 5 mm Washer (9)
E Hex Nut No. 10 (9)
F 3/8" Screw (0)
G Hex Nut (0)
H 3/8" Self tapping screw (34)
I  / " Hex Bolt ()
1
4
J 5/16" Hex Nut ()
B
A
C
D

BASE ASSEMBLY

1. Turn base upside down. Attach  wheels,
 axles (I) and  nuts (J) as shown in
Figure 3. Do not overtighten.
. Attach 4 base feet to base weight with 4
washers (B) and 4 screws (A) as shown
in Figure 4. Feet will install over raised
areas underneath base weight.
3. Being careful not to scratch paint, lay
cabinet base onto back side (use foam
packaging block to support rear top of
cabinet base). Align holes in bottom
edges of cabinet base with holes in base
as shown in Figure 4. Attach with 1 screw
(C), 1 washer (D) and 1 nut (E) for each of
the 9 holes (see Figure 4). Set assembly
upright.
4. Attach base to weight with 4 screws (A)
and 4 washers (B) as shown in Figure 4.
5. Install chain retainers ("S" hooks) to upper
edges of cabinet base as shown in Figure 4.
6. Install electronic ignitor through cabinet
wall as shown in Figure 4. Hand tighten.
118994-01F
Part No.
119619-01
119600-04
119619-03
119600-0
NPC-3C
119619-06
NPC-1C
11960-0
HC4-18C
NPC-5C
E
I
F
J
G
H
www.desatech.com
7. Attach tank door to cabinet with 4 screws
(F) and 4 nuts (G) as shown in Figure 4.
Set entire assembly aside.
Wheel
Nut
Base
Figure 3 - Attaching Wheels to Base
Chain
Retainer
Cabinet
Base
Tank
Door
Base
Base
Weight
Base Foot,
Washer and
Hex Bolt
Figure 4 - Cabinet Base Assembly
Axle
Retainer
Ignitor
Ring
Ignitor
Cap
5