Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
1
Slot the left hand connector
d own onto the bottom connecting bracket
side bar. Ensure this is secure.
2
Slot the right hand connector
piece down onto the bottom connecting bracket
right hand side bar. Ensure this is secure.
3
Slot the right hand connector
down onto the top connecting bracket
side bar. Ensure this is secure.
4
Slot the left hand connector
down onto the top connecting bracket
bar. Ensure this is secure.
3
ASSEMBLY (Continued)
5
14
of the bottom telescopic piece
8
on the left hand
6
14
of the bottom telescopic
8
on the
7
6
of the top telescopic piece
17
on the right hand
8
6
of the top telescopic piece
17
on the left hand side
11
Using a flat-head screwdriver, loosen the screw set
bottom telescopic piece, but not so much so that they are
loose enough to be removed. (Screwdriver not included). For
12
screens larger than 1500, remove the bottom
and top
centre telescopic beam and replace it with the 1700mm
beam provided.
Using a flat-head screwdriver, loosen the screw set
11
top telescopic piece, but not so much so that they are loose
enough to be removed. (Screwdriver not included)
1 7
Holding the side bars in the centre
, you can adjust the
length of the bracket by either pulling or pushing the two sides
together. Once you have lined the length of the projector
screen with the bracket, tighten the 2 screw sets
11
from
Step 5 & 6.
1
7
Unscrew the bolt set
15
on the left
and right
hand side
bars and fasten the screen to the bracket ensuring the
washers are in place.
on the
4
2
10
on the
4
Publicité
Table des Matières
