Kimpex 374150 Instructions D'assemblage page 7

" CLICK N GO 2 " PLOW ATTACHMENT
BRP Commander
6) Tighten all bolts and nuts assembled so far with an
appropriate tool.
Assembly of the V-plate to the attachment
plate
7) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and four (4) M8-1.25 hex. nuts
the holes corresponding to the width of the four (4)
slotted holes of the attachment plate
first threads only so as to leave a space between the
head of carriage bolts
8) Assemble one (1) M8-1.25 x 20 mm hex. bolt
one (1) M8-1.25 hex. nut
plate . Tighten the bolt with an appropriate tool.
A
C
A
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2 2 810483 A A -2810483 Imprimé en Chine / Printed in China
ASSEMBLY INSTRUCTIONS
on the V-plate
D
. Screw the
01
and the V-plate .
C A
and
E
on the centre of the V-
D
E
D
9) Assemble the V-plate
by first aligning the rear carriage bolts
carriage bolts
B
02
01
A
10) Once the carriage bolts
the slotted holes of the attachment plate
them well using an appropriate tool.
C
Position of the push frame hook assembly
in
A
Install the push frame hook assembly in Position 2. Refer
to the instructions for the push frame for the assembly
procedure. It is possible that the position must be
changed to fit the winch installed on the vehicle.
374150
NO.
KIMPEX
on the attachment plate
A
C
.
C
inserted to the bottom of
C
01
and front
, tighten
01
2