MOB MO9212 Guide D'utilisation page 3

Heart Monitoring Mode
In normal time mode, press key D once to start timing, and at the same time, heart monitoring starts. There will be "BB" alarm tone when
an out-of-limit heart rate is measured. During the timing process, press key D once to stop timing. It displays the average heart rate value
and timed time for 2 seconds each alternately.
In t h e heart monitoring mode, when t h e heart rate signal is received, it updates the heart rate value
about every 5 seconds; Without a heart rate signal, it enters power saving mode 5 seconds later, and heart rate value displays as zero,
heart rate symbol disappears.
In timing stop mode, press key D to continue with timing.
In timing stop mode, press and hold key D for 2 seconds, the timed time and heart rate value are reset to zero. Then it exits and returns to
normal time mode automatically.
Use Instruction on Heartbeat Chest Band:
To wear chest band, face the battery cover of the chest band transmitter down, then adjust the transmitter to the center of your chest.
The chest band is used to record heart beat r a t e and transfer the data to the wristw a t c h .
Please pay attention to the following when wear your chest band:
- Get the conductive mat on inner side of the chest band wet with several drops of water or conductive gel to ensure good
contact.
- Wear the chest band next to your chest. To ensure accurate heart rate signal, please adjust the binding belt properly and ensure it fits sits
comfortably on your chest
.
Heart rate signal can be transferred within 2 seconds after the band is being worn. Now you can receive heart rate value in heart
monitoring mode. " " flashes when heartbeat signal is receive
Tips:
The location of chest band may affect its performance. Please move the chest band along the binding belt to ensure it locates your heart
rate.
Avoid wear your chest band at the position with extremely hairy parts of the chest.
In dry and cold weather, it may take several seconds for chest band to perform normally. This is normal phenomenon. After several
seconds' heating up, it will perform correctly
As illustrated below, you can either wear your wristwatch on your wrist or fix it on bicycle or exercise machine with a distance ≤65cm from
chest band transmitter.