Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the WL-250 MK2 will respond to the controller.
If you set, for example, the address to channel 5, the WL-250 MK2 will use the channel 5 to 8 for control.
Please, be sure that you don't have any overlapping channels in order to control each WL-250 MK2 correctly
and independently from any other fixture on the DMX-chain.
If several WL-250 MK2 are addressed similarly, they will work synchronically.
In order order to control the device via DMX, DIP-switch no. 10 and 11 must be set to OFF, the starting
address is selected via DIP-switches 1-9.
Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20
Now you can start operating the WL-250 MK2 via your lighting controller.
DMX-protocol
Control channel 1 – Shutter/Dimmer
Control channel 2 – Cyan
DMX-value
Feature
0-255
Cyan (0=white, 255=cyan)
Control channel 3 – Yellow
DMX-value
Feature
0-255
Yellow (0=white, 255=yellow)
Control channel 4 -– Magenta
DMX-value
Feature
0-255
Magenta (0=white, 255=magenta)
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
1
2
3
DIP-switch no.
DMX-starting
1
2
4
address
On
Off
Off
On
Off
On
Off
On
Off
On
Off
21/43
4
5
6
7
8
9
8
16
32
64 128 256
00026452.DOC, Version 1.1