Mounting And Installation; Cutout Dimensions; Mounting - Phoenix Contact EMpro EEM-MA600 Instructions D'installation

English
4

Mounting and installation

4.1

Cutout dimensions

U
Figure 1 Cutout dimensions
4.2

Mounting

Figure 2 Mounting
To ensure that the device is securely placed on the front panel, the device must be pressed into the mounting slot from
the front and then secured from behind using the four clamps provided.
To mount the device, proceed as follows:
1. Press the device into the mounting slot from the front and hold it in this position.
2. Secure the device from behind with the four clamps, as shown in Figure 2.
3. Push the clamps as far as they will go onto the latch, until the device is securely positioned and the clamps snap
into place.
2 PHOENIX CONTACT
4 5
6 0
8 0
104513_en_03