Feit Electric 74050 Instructions

MODEL 74050, 74051
LED FLAT PANEL FIXTURE INSTRUCTIONS
CAUTION
TURN OFF THE MAIN POWER
AT THE CIRCUIT BREAKER
BEFORE INSTALLING THE
FIXTURE, IN ORDER TO
PREVENT POSSIBLE SHOCK.
MOUNTING INSTRUCTIONS
READ IMPORTANT SAFETY INFORMATION FIRST ON REVERSE SIDE OF THIS SHEET.
1. To attach the Mounting Bracket to the Junction box in the Ceiling, follow these steps:
a) Twist and unlock the Mounting
Bracket from the round LED flat panel
fixture to remove.
i) Use a pencil to mark the two hole positions for the
plastic anchors going in the ceiling.
2. Connect the wires by raising the lamp Unit up to the ceiling in two steps (Notes: For larger fixtures a second person may be needed to hold the Lamp unit)
a) Hook up support wire as shown to hold fixture while
you make the electrical connections
Support Wire
SAVE THESE INSTRUCTIONS.
FEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.com
GENERAL
All electrical connections must be in accor-
dance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with
proper electrical wiring connections obtain
the services of a qualified electrician.
b) Determine if the ground wire is inside
the junction box. If not, then secure
ground wire provided to the Mounting
Bracket as shown.
Ground screw
Ground Wire
ii) Remove the bracket and install plastic anchors
provided where marked. Use a 1/8" drill bit to make
a hole and insert plastic anchor into each hole by
tapping gently.
b) Feed lamp Unit wire through mounting bracket
center holes, using the wire nut connectors
provided connect the 3 wires coming from the
j-box as show (Black-line voltage, White-com-
mon, Green- ground)
Remove the fixture and the mounting
Remove the fixture and the mounting package
from the box and make sure that no parts are
package from the box and make sure that
missing by referencing the illustrations on the
no parts are missing by referencing the
installation instructions.
illustrations on the installation instructions.
c) Identify all three wires (Black-line
voltage, White-common, Green-
ground) from ceiling and make them
accessible for easy connections.
White
Green
Black
iii) Screw mounting bracket into the junction box and
plastic anchors until secure
Wire Nuts
PARTS INCLUDED:
1. Mounting Bracket
2. Lamp unit
3. #8-32 x 1 screws
4. Ground wire
5. Ground screw
6. Plastic anchors
7. Wire nuts
d) Secure the bracket to the junction box
using the Junction box screws
provided. If securing the bracket with
anchors is also desired, follow steps i
to iii. Otherwise, proceed to step 2
QTY
1
1
4
1
1
2
3