Kolpin POLARIS RZR 900 Instructions D'installation page 2

b) Find a clean flat area where you can safely lay down the rear lower windshield (Item B). Partially remove the protective film and
apply the self adhesive foam cushion (Item C) to the lower lip using manual pressure to ensure good adhesion to the windshield and
cut any excess.
Self adhesive foam
cushion (+/- 46 ½")
Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
c) Attach the windshield to the vehicle using supplied hardware as shown below. Adjust position and tighten all hardware.
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of
Recommended products: Johnson Paste Wax, Novus Plastic Polish #1 and #2, Mirror Glaze plastic polish and Plexux1.
Testing polish on a separate Lexan sample is recommended. Be sure to follow product instructions carefully.
2751 - Instructions POLARIS RZR 900 Rear Windshield - rev00
IMPORTANT NOTICES
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
light transmission and coating delamination.

Aqueous Solution of Soaps and Detergents
Joy Freon T.F. Palmolive liquid
MINIMIZING HAIRLINE SCRATCHES
For minimizing scratches and minor abrasions, mild automobile polish can be used.
warranty.
Flange locknuts
M6
Shoulder
washers M6
Philips
truss screw
M6 x 20
Philips truss
screws M6 x 24
CLEANING:
or use brushes or squeegees.
rinse. DO NOT USE GASOLINE.
Compatible Cleaning Agents
Top Job
Rear lower
windshield
Shoulder washers M6
VM&P grade Naphtha Windex
(with ammonia D)
www.kolpin.com
Round
spacer ½"
2