1
IS ALWAYS IN STANDBY MODE AND WAITING FOR THE FINGERPRINT
When a finger is placed on the sensor, the reader needs approximately one second to open the door.
2
ENROLLS AND DELETES FINGERPRINTS
Every operation is started by pressing the corresponding button on the control unit. All procedures are
described in this manual.
3
CAN PERFORM FACTORY RESET
Factory reset operation can be performed by pressing R button on the control unit and holding it for 10
seconds. It deletes all fingerprints from the memory (administrator fingerprints included).
4
TRIGGERING OF ADDITIONAL FUNCTION
It enables opening of an additional door or triggering of a device. Triggering of the additional function can
be assigned to each enrolled fingerprint. The procedure is described in fingerprint enrolment section of this
manual.
5
USES HIGH SECURITY PROCEDURES AND COMPONENTS
Enrolment of a user can only be performed after confirmation by the administrator while the communication
between the fingerprint reader and the control unit, installed inside the door leaf, is encrypted by 256-bit
encryption.
Whenever an operation is not concluded (a fingerprint is not enrolled or deleted) the operation will auto-
matically time out after 1 minute.
•
Fingerprint capacity: 1000
•
Power supply voltage: 8-30 V, AC or DC
•
2 relay outputs
•
Maximum current on the relay: 3 A
•
Relay triggering time: 2 s
•
Maximum power: 1,8 W
•
Fast fingerprint recognition: <1,2 s
•
Operating temperature range: -30 ºC to +80 ºC
•
Maximum environmental humidity: 100 %
•
Fingerprints will remain in the memory in the case of power failure.
•
Latest generation Authen Tec TCS1CT capacitive sensor, 508 dpi resolution
•
User interface: multicolor LED, beeper, 3 buttons on the control unit
WHAT DOES INOKEY DO?
TECHNICAL DATA
EN
29