Table des Matières
Publicité
Area of use
The product is intended for both indoor and outdoor use. The product is not resistant to moisture or careless treatment.
Mounting of batteries and belt clip
1.
Remove the belt clip by lifting the small locating tab while pushing the clip upwards.
2.
Remove the battery cover by pushing it downwards.
3.
Insert the rechargeable batteries, ensuring correct battery polarity is observed.
4.
Refit the battery cover and belt clip.
Charging
Connect the mains adaptor to an electrical wall socket and to the socket of the charging unit. Place the handset in the charger
with the buttons facing out. It is also possible to charge the handset by connecting the mains adaptor directly to the headset
socket. The displayed battery indicator 3 consists of three segments. The segments disappear one after another as the
battery charge decreases.
The battery indicator will show 3 when charging is complete (approximately 10 hours). Fully-charged batteries will last for
approximately 35 hours in standby or 2 hours operational time. The given times apply at normal room temperature.
Please note!
The batteries must be mounted and the product must be charged for 24 hours before initial use.
Switching the Handset on/off
Press and hold 1 for a few seconds to turn the handset on or off.
Volume control
The sound volume is adjusted with v / V in standby.
To communicate
1.
Make sure that all handsets are set to the same channel and transfer code. See below.
2.
Press and hold PTT (Push To Talk) to speak.
3.
When needed send call signal through quickly pressing
If the handsets are unable to communicate, it may be because different channels or transfer codes have been selected, that the battery is running low or
that the units are too far apart.
Headset
The headset socket is placed next to the antenna. Use the PTT button on the headset cable.
Adjust the sound volume directly when installing a headset.
Channel selection
All equipment using this frequency share the available designated channels. If the chosen channel is in use select an alternate
channel. The selected channel will be displayed in standby mode.
1.
Press w .
2.
Select the desired channel using v / V .
3.
Press PTT.
Transfer code selection
There are 38 transfer codes available which can be used to filter out unwanted signals. However, your conversation may still be
overheard irrespective of which code is used. To enable communication in both directions, the same transfer code must be used
on all handsets. In order to communicate with equipment that cannot select a code, enter code 0.
1.
Press w twice, the small digits will then be flashing.
2.
Scroll to the desired transfer code using v / V .
3.
Press PTT.
English
7–10 km 200–600 m 50–150 m
.
Publicité
Table des Matières
