Ryobi RSH2400R Manuel D'utilisation page 13

GB
F D E
GENERAL SAFETY RULES
10)Keep all guards and deflectors in place and in good
working condition;
11)Do not tamper with the power source settings;the
controls the safe maximum operating speed and
protects the power source and all moving parts from
damage caused by over-speed.Seek authorised
service if a problem exists;
12)Do not transport the machine while power source is
running;
13)Shut off the power source and disconnect the spark
plug lead (electric unit disconnect from supply)
whenever you leave work area;
14)Do not tilt the machine while the power source is
running.
MAINTENANCE AND STORAGE
1) When the machine is stopped for servicing, inspection,
or storage, or to change an accessory, shut off the
power source, disconnect the spark plug wire from
the spark (electric unit disconnect from supply), make
sure that all moving parts have come to a complete
stop and, where a key is fitted remove the key. Allow
the machine to cool before making any inspections,
adjustments, etc.;
2) When servicing the cutting means be aware that,
even though the power source will not start due to the
interlock feature of the guard, the cutting means can
still be moved by a manual starting mechanism.
3) shut-off the power unit before attaching or removing
the bag.
ELECTRICAL SAFETY AND PLUG FITTING
WARNING!
- Read these safety instructions thoroughly before
connecting this product to the mains supply.
- Before switching on, make sure that the voltage of
your electricity supply is the same as that indicated on
the rating plate. This product is designed to operate
on 230-240V~AC 50Hz.
- Connecting it to any other power source may cause
damage.
- This garden shredder may be fitted with a non - plug.
- If it is necessary to change the fuse in the plug, the
fuse cover must be refitted.
- If the fuse cover becomes lost or damaged, the plug
must not be used until a suitable replacement is
obtained.
I P NL S DK N FIN GR HU CZ RU
English
- If the plug has to be changed because it is not suitable
for your socket, or due to damage, it should be cut
off and a replacement fitted, following the wiring
instructions shown below.
- The old plug must be disposed of safely, as insertion
into a 13 amp socket could cause an electrical hazard.
- Our Garden Shredder is supplied with a fitted plug,
however if you should need to fit a new plug follow the
instructions below.
- If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
NOTE: If a plug is fitted and has to be removed take
great care in disposing of the plug and severed cable. It
must be destroyed to prevent engaging in a socket.
IMPORTANT
The wires in the mains lead are in accordance with the
following code:
Blue — Neutral,
Brown — Live,
As the of the wires in the mains lead of this appliance
may not correspond with the markings identifying the
terminals in your plug, proceed as follows:
The wire which is blue must be connected to the terminal
which is marked with N or black.
The wire which is brown must be connected to the
terminal which is marked with the letter L or red.
If a 13 AMP (BS 1363) Plug is used, a 13 AMP Fuse
must be fitted, or if any other type of plug is used a 13
AMP Fuse must be fitted, either in the Plug or Adaptor, or
on the Distribution Board.
Ensure that the outer sheath of the cable is firmly held by
the clamp.
10
RO PL SLO HR TR EST LT LV SK BG