Finishing The Installation; Attaching The Fan Blades - AirPro Progress Lighting P250021 Manuel D'installation

Finishing the Installation

Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 12)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger ball
before attaching the canopy to the bracket by
turning the housing until it drops into place.
7.
Outlet box
Hanger
bracket
Figure 12

Attaching the Fan Blades

Step 1. Attach the blade medallions A to the blade
end using the two Allen screws, flat washers, and
nuts. Secure tightly with the Allen wrench
provided. (Fig. 13)
Step 2. Attach the blades to the blade bracket using
six Allen screws, flat washers and medallions B.
Secure tightly with the Allen wrench provided.
Make sure the blade is straight. (Fig. 14)
Step 3. Fasten the blade assembly to the motor
using the motor screws provided. (Fig. 14)
Step 4. Repeat these steps for the remaining
blades.
Allen screws
Allen wrench
Screws
Figure 13
Canopy
Canopy cover
Figure 14
Blade
Nuts &
flat washers
Blade
medallions A
Allen wrench
Blade bracket
Allen screws
& flat washers
Blade
Allen screws
& flat washers
Blade
medallions B