Safety First (Important); General Safety - Makeblock mCreate Manuel D'utilisation

Safety First (Important)

The nozzle and the build plate of mCreate have warning labels on them. These labels indicate any potential hazard that may
cause injury to you or others, or damage to the product or property.
DO NOT touch any part
inside the mCreate,
including but not
limited to the nozzle
and build plate,
WARNING
when the printer is in
operation.

1. General safety

Read and get familiar with all safety protocols and procedures before operating mCreate. You shall strictly follow all safety precautions
and ensure that the mCreate is properly assembled and in working order.
Please observe the following operating principles:
·Be sure to check mCreate for damage every time before use. DO NOT operate any damaged or defective mCreate in any way.
·Please keep the workspace clean, flat and stable. Any shake during operation may lead to a lower printing accuracy or even layer
shifting.
·Operate mCreate in a well-ventilated area.
·Assemble mCreate as instructed in this Manual. DO NOT disassemble or change the printer's structure in any other way; and DO NOT
modify or decompile the operating system of mCreate on your own.
·DO NOT leave mCreate unattended for a long time when the printer is in operation.
·Children under 12 years old shall use the printer under adult supervision.
HIGH HIGH
WARNING WARNING
HOT
TEMPERATURE TEMPERATURE
DO NOT TOUCH
Hot parts! Burned
fingers when handing
the parts. Wait one-half
hour after switching off
before handing parts.
HIGH
HOT
TEMPERATURE
DO NOT TOUCH
Keep your hands away
from the build plate
until mCreate cools
down.
HOT
DO NOT TOUCH
17