Important - Victron energy CAN-bus Manuel

Installation

Important!

Basic settings
When using the device for the first time, the following basic settings must be applied:
Programming the threshold value
• Connect the CAN-bus temp sensor to an 800C/1600 using the CAN-bus cable
• Tick checkbox 80 and enter the desired parameters
• Click on "Send all settings to converter"
• No more than 4 seconds later, the green LED on the CAN-bus temp sensor will flash 3 times to confirm
After starting up the 800C/1600 or after a reset, it will take no more than 4
seconds before the CAN-bus temp sensor sends a CAN message to the converter.
Until a message has been received, the words "no signal" may be displayed in the
TSConfig monitor window.
If the connection to the CAN-bus temp sensor is lost (due to a cable break), the 800C/1600
will indicate "no signal" no more than 12 seconds afterwards. If this happens, the
temperature threshold programmed in on the 800C/1600 will not be used
to limit the charging voltage.
Setting the CAN-bus temp sensor as a stand-alone module
If the CAN-bus temp sensor is being used as a stand-alone module, a temperature (alarm) threshold value
must be programmed first of all.
Programming a threshold value can only be carried out using an 800C/1600 and TSConfig Software.
Alarm
If the temperature has reached the threshold value (= converter off), the converter will be switched off
(switching on will be blocked).
The block will not be lifted until the temperature has risen above the alarm threshold for a period of 5
minutes.
7