in-lite AML(S)-11A Manuel D'utilisation page 4

EN
Contents
1x AML(S)-11A (HIGH) 12 V / 20 W
1x halogen lamp
1x ground stake
2x fixing screws
1x Easy-Lock
Material
Aluminium housing, high quality plastic lens.
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Use
Above-ground lighting suitable for the yard or to mark a pathway, drive
or patio.
Lamp
Halogen lighting gives a bright beam that is particularly suitable for
illuminating objects and special places.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.
EN
Connecting the fixture to 12 V
Step 1
Remove the plastic lens from the fixture by turning it anti-clockwise.
Remove the fitting holder from the fixture and install the lamp in it.
Replace the fitting holder in the fixture. Replace the plastic lens and
turn it to tighten it.
Step 2
The fixture can be mounted on a hard surface using the screws sup-
plied or in soft surface using the ground stake supplied. The ground
stake is easily fixed by screwing it in the underside of the foot of the
fixture.
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 1)
a. There are two cable grips. The grip with the wider recess fits the
10/2 main cable, the grip with the narrower recess fits the 14/2
main cable. Clamp the correct cable grip over the main cable.
b. Put the cable grip (with the cable underneath) in the Easy-Lock
connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 2)
Replacing the lamp
Caution! Before replacing the lamp it should have been switched off
for a minimum of 10 minutes to allow it to cool. Then use a soft cloth to
replace the lamp. Avoid direct contact with the lamp; grease and salts
from the skin can considerably shorten the service life. To replace the
lamp see step 1.
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3 and 4. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.