Ec Declaration Of Conformity; Lubrication - Sunex HD SX7235 Mode D'emploi

Instruction Manual
This tool is designed for sanding or polishing.
No other use is permitted.
Air Supply Requirements
Tool is designed to operate at 90 psi (6.2 bar) at free speed
measured at the tool, of clean, dry air. Operating this tool at higher
pressures will drastically reduce the tool life and could cause injury.
Whip Hose
Do Not Install
Quick Coupling Nipple
Here
Leader Quick Coupler
Hose
Backing Pad Replacement
Place rod (43) into side slot of hub (24). While holding the hub,
place the hex key wrench (42) in the screw (26). Turn the screw
clockwise to loosen it. The flange washer (25) will fall out
when the tool is tipped forward. To assemble, reverse previous
instructions.
The air inlet thread on this tool is a standard 1/4" NPT. Line
pressure should be increased for any unusually long air hose run
(over 25 feet). Minimum hose diameter should be 3/8" I.D. and all
fittings should have the same inside diameter. See diagram to the
left for proper air supply setup.

Lubrication

Lubricate the tool each day after use with quality SAE #10 air
motor oil. Add the oil to the air inlet or into the hose at the nearest
connection to the air supply, then run the tool until all excess oil
is expelled from the exhaust. Total oil quantity needed for this
procedure is approximately 1 ounce. If using an air line lubricator
adjust to two drops per minute.
SX7235: Parts Breakdown & Operating Manual
Air Supply
Filter
Nipple
Oiler Regulator
Drain Daily

EC DECLARATION OF CONFORMITY

We, Sunex International Inc., 315 Hawkins Rd, Travelers
Rest, SC 29690, declare under our sole responsibility that
the product to which this declaration relates, is in conformity
with the requirements of the Council Directive of 2006 on the
approximation of the laws of the Member States relating to
machinery. (EN792, 2006/42E)
Harmonized Standards Applied:
TC255N, EN792-6
National Standards Applied:
EN 28662-1 & EN28662-7:1997
Machine Name:
SX7235 Reversible Hi-Speed Sander
Serial No.:
MS0122401 or higher
Techical Data:
Free Speed: 16,000 RPM
Air Pressure: 90 psi (6.2 bar)
Noise and Vibration Declaration
Tool produces a noise level (no load) of 91 dBA
sound pressure with 3 dBA uncertainty per
EN ISO15744-2008. Vibration level is <3.16 m/s
tested per EN28927-3
Signature of Issuer:
Name and Position of Issuer: John Stratton, Product Manager
Sunex International Inc.
Date of Issue: March 9, 2012.
Specifications
Pad Size .................................................................3", 4", 5"
Free Speed ........................................................ 16,000 RPM
Length .............................................................5.5" (142mm)
Weight ......................................................... 2.2 Lbs. (1.0 kg)
Avg. Air. Cons. .............................................4 cfm (113 l/min)
Air Inlet ................................................................... 1/4" NPT
Min. Hose Size ............................................ 3/8" I.D. (10mm)
3
2
05/09/12