Sartorius YDP20-0CE Installation Et Mode D'emploi page 8

8
Inserting the Paper Roll
§ Insert the paper roll as described in "Maintenance" on
page 33
Setting the Date and Time
§ For instructions on setting the date and time,
please refer to "Configuration" on page 20.
If you connect the printer to an instrument
that does not supply sufficient voltage to the YDP20-
0CE, use only an original Sartorius AC adapter (external
power supply) for this printer
(see "Accessories").
Contact your Sartorius dealer if you need an external
power supply. The external power supply is required,
for example, if the printer is connected to one of the
following devices:
– MP8-1/MP8-2 weighing instrument with data input
software
– Economy Series weighing instrument
(model EA..., EB...)
– Infrared dryer, model 7393.../YDU01L
– External keyboard, such as model 73392
§ Plug the original Sartorius AC adapter into an
electrical outlet
§ Insert the right-angle plug into the jack on the right-
hand side of the printer's rear panel.
The green LED lights up to indicate that the printer is
energized.
$ Install the batteries (see page 6)
$ Connect and switch on the printer and the weighing
instrument as described in the previous section