Printer Port Settings - Sartorius YDP20-0CE Installation Et Mode D'emploi

24

Printer Port Settings

You can prevent unauthorized changes in this configu-
ration menu by defining a four-digit number (PIN) as
a password. If you lose or forget this number, contact
your local Sartorius Service Center.
All settings are loaded in the printer's memory
(EEPROM) when the printer is switched on and applied
during operation.
There are two ways to open the menu for configuring
printer port settings:
– Hold down the P key when you switch on the print-
er, or, during operation,
– Press and hold the P key for at least 5 seconds
The T, I, U and Y keys then have the
navigation functions indicated by the arrows.
The diagram on the next page illustrates the procedure
for configuring the "Code" (PIN code) and "Baud" (data
transfer rate) settings. All parameter options in the
printer port configuration menu
are listed on the subsequent page, following the dia-
gram.
To print the menu settings, open the Setup menu and
press the P key.
Note:
The "C" or "L" printed after the program version num-
ber indicates whether menu settings can be changed:
C: "Change" Settings can be changed
L "Locked" The menu is locked; settings cannot
be changed
Note:
The time cannot be set when the menu is locked.