M U Sic Con T Rol - Buttons Air X Manuel D'utilisation

BUTTONS Air X Earphones are configuredwith three modes (ANC, ambient sound
and standard), and you can switch between them as needed.
ANC Mode: this mode achieves a noise reductionup to 35dB, eliminating
most noise interference at low frequency bands, and giving the user a quiet
listening experience;
Ambient Sound Mode: in this mode, ambient sound is collected and played
in the ears to improve the perception of the external environment so that the
ambient sound outside the ears can be clearly heard;
Standard Mode: in this mode, the active noise cancellation and ambient
sound functions are disabled, and the earphones are only used as TWS
earphones.
Mode Switch:
After connecting and wearing both earphones, tap the
touch panel on the left earphone to switch between ANC /
ambient sound / standard modes.
Enter ANC Mode:your earphones issue a single beep tone and/or a voice
prompt of "ANC on";
Enter Ambient Sound Mode: your earphones issue two beep tones and/or a
voice prompt of "Ambient sound on";
Enter Standard Mode: your earphones issue three beep tones and/or a voice
prompt of "Ambient sound off";
Note:
The default mode of the earphones is ANC mode;
Mode switch cannot be performed when only one earphone is used.
Play/Pause
Using both earphones: Tap the touch panel on the right-side
earphone one time to pause & play music
Using one earphone: Tap the touch panel on the earphone one
time to pause & play music
Track Switch
Previous: Double-tap the touch panel on the left
earphone
Next: Double-tap the touch panel on the right
earphone
Volume Control
Volume Up: Press and hold the touch panel on
the right earphone for 1s
Volume Down: Press and hold the touch panel on
the left earphone for 1s
Note:
The system will issue two beeps when the volume is adjusted to the maximum or
minimum.
1333-16国语言版-120x120v10.indd 4
Smart Noise Cancellation

M u sic Con t rol

C a ll C on tro l
Answer Calls
Using both earphones: Tap the touch panel on the right earphone
one time to answer a call
Using one earphone: Tap the touch panel on the earphone one time to answer a call
Reject Calls
To reject a call, double-tap the touch panel on either earphone
End Calls
To end a call, tap the touch panel on either earphone during the
call
Call Volume Control
Volume Up: Press and hold the touch panel on the right
earphone for 1s
Volume Down: Press and hold the touch panel on the left
earphone for 1s
Vo i ce Ass ista n t
To enable the voice assistant, tap the touch panel on either
earphone for three times
Wea r in g De te ct io n & Slee p Mo d e
Wearing Detection
While music is played, the music will
automatically pause when you take off either
one or both earphones and will resume when
you put on the earphone(s) again.
During a phone call, the telephone receiver will
be enabled when you take off both earphones,
and the earphone speakers will be enabled
when you put on either or both earphones.
Note:
Touch control is not supported if your earphones are
detected not be worn.
Sleep Mode
Enter Sleep Mode: The earphones will
automatically enter sleep mode in case of failing
to pair with a Bluetooth device, being taken off
and not used, or being out of bluetooth range for
certain duration;
Exit Sleep Mode: Put your earphones back into
the charging case, and then take out again to exit
sleep mode.
4
2020/4/30 18:29:03