Telefunken TKVCL3 Mode D'emploi page 34

ENGLISH
3. Operating the unit
Selection Operating instructions on control panel or remote control
ON/OFF : Press one time on the button to switch on or off your appliance.
Mode : Press this button to select your desired program: cooling, heating, fan or
dehumidifying.
The temperature could be set between 180°C and 30°C in cooling and heating mode.
Fan function : Press the button until your desireed speed level shown on the display :
High Medium Low High
Note: In dehumidifier mode, the speed fan is set at low level.
Up : Press to increase the temperature or time setting
Down : Press to decrease the temperature or time setting
Timer : Allow you to set the used time. Press the button on time, the icon will flash
on the LCD display
and "88" will show to indicate 24:00. You can start setting your time with
and . Note: The hour setting run from 1 to 24h and the minutes setting run every 10
Up to 5 hours, you can set the timer every 30 minutes. Over 5 hours, the hour
minutes.
setting is every hour.
Sleep mode: This automatic program allows low energy consumption with the fan
speed set on low level when using the colling mode. To activate this mode simply press
the button once and the LCD screen will show the icon. The device only decrease by 2
° C in cooling mode for a period of two hours after activation of this mode then the
temperature will stabilize during the reminder of the time. Note that at each
interruption of power supply, this mode is canceled, you must press the button again
to reactivate it.
Swing function: This program allows to automatically set the air flow direction. You
only need to press on the button one time to switch or off this function.
Max cooling function, you only need to press on the button one time to switch or off
this function.
This button allows you to choose the temperature degree display in Celsius or
Farenheit.
15