Installing; Receiver Location; Optional External Equipment; Remote Control Battery Installation - HP Pavilion PE4200N Mode D'emploi

Receiver Location

This unit is intended to be used with the stand. Consult
your dealer for available options. Position for
comfortable viewing. Avoid placing where sunlight or
other bright light (including reflections) will fall on the
screen. Use of some types of fluorescent lighting can
reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal
component failure. Keep away from areas of excessive
heat or moisture.
Optional External
Equipment
The video and audio connections between components
can be made with shielded video and audio cables.
For best performance, video cables should utilize
75-Ohm coaxial shielded wire. Cables are available
from your dealer or electronic supply store.
Before you purchase any cables, be sure you know
what type of output and input connectors your various
components require. Also determine the length of
cable you will need.
Remote Control Battery
Installation
1
Open the cover.
2
Install the batteries and replace the cover.
Note the correct polarity (+ and –).
6
HP Pavilion Plasma TV User's Guide

Installing

Replace used batteries with alkaline
batteries for longer life.
CAUTION: Incorrect installation can cause
battery leakage and corrosion that will
damage the remote control transmitter.
Observe the following precautions:
Batteries should always be replaced as a
■
set. Always use new batteries when
replacing the old set.
Do not combine a used battery with a
■
new one.
Do not mix battery types (example: "zinc
■
carbon" with "alkaline").
Do not attempt to charge, short-circuit,
■
disassemble, heat, or burn used
batteries.
Battery replacement is necessary when
■
remote control acts sporadically or stops
operating the TV set.
When not using the remote for a long
■
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
Do not try to recharge batteries that are
■
not intended to be recharged: they can
overheat and rupture. Follow the battery
manufacturer's directions for the
batteries you are using.
n
w