Sunex Tools 4940A Instructions D'utilisation page 3

Operating Instructions • Warning Information • Parts Break­down
RAM LOAD
never lift a load that exceeds the capacity of
the ram. Do not over-extend the ram, because
it is possible to force the plunger out of the
top of the ram.
THREAD PROTECTION
when possible, protect ram with threaded
protector ring and saddle as illustrated.
DUST CAPS
when coupler valves are disconnected, screw in
dust caps to keep the oil lines clean.
OFF-CENTER LOADS
Be careful when load is not centered on ram
plunger. Pump carefully - iF You Feel THAT
You HAVe To PuMP unusuAllY HArD -
sToP oPerATion. Adjust set-up so the
off-center load is not so great.
PROTECT yOUR HOSE
Do not drop heavy objects on your hose and
avoid sharp kinks. Provide proper clearance to
avoid damage to the hose and couplers.
HEAT AND FIRE
Always keep your equipment away from
excessive heat or fire. Heat always weakens the
equipment.
OWNER/USER RESPONSIBILITy
The owner and/or user must have an understanding of the
manufacturer's operating instructions and warnings before using
this equipment. Personnel involved in the use and operation of
equipment shall be careful, competent, trained, and qualified
in the safe operation of the equipment and its proper use when
servicing motor vehicles and their components. warning information
should be emphasized and understood. if the operator is not fluent
in english, the manufacturer's instructions and warnings shall be
read to and discussed with the operator in the operator's native
language by the purchaser/owner, making sure that the operator
comprehends its contents. owner and/or user must study and
maintain for future reference the manufacturer's instructions.
owner and/or user is responsible for keeping all warning labels
and instruction
4940A
VERSATILITy
use the 0 Ton Pump with
the Multi-Directional
ram, and attachment
combinations,
some of which
are shown below.
TIGHT PLACES
For the difficult places to get
into, use the spreader.
RAM ATTACHMENT COMBINATIONS
Some of the hundreds of combinations possible.
rAM
ruBBer
HeAD
rAM
ruBBer
HeAD
SAFETy PRECAUTIONS
Oil Level
collapse ram if connected to pump. Place
pump in an upright position as shown.
remove filler plug and add hydraulic oil
until it is level with the full mark on the stem.
3
eXTension
rAM
ruBBer
HeAD
PuMP
sPreADer
rAM
FlAT
FlAT
BAse
BAse
ruBBer
sADDle
rAM
HeAD
FlAT
BAse
sPoon
rev. 08/0/06