Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SaFetY and GeneRaL InFORMatIOn
Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use it. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from the manufacturer.
PROdUct deScRIPtIOn
Hydraulic Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads must
be supported by a pair of appropriately rated jack stands. This Fast Lift service jack has a unique feature that provides
fast, no load lifts to the jacking point, at which time it lifts in approximately 1/4"~3/4" increments.
NEVER use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle with
!
a pair of appropriately rated jack stands.
PRePaRatIOn
assembly
Insert handle into the handle fork. Tighten the bolt on handle fork to prevent accidental removal of handle while in
use.
Before Use
1. Verify that the product and application are compatible, if in doubt call
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, locate and turn the release valve (handle):
a. Clockwise until firm resistance is felt to further turning. This is the 'cLOSed' release valve position used to
raise the saddle.
b. Counter-clockwise, but no more than 1/2 turn from the closed position. This is the 'OPen' release valve
position used to lower the saddle.
4. With saddle fully lowered, remove the oil filler plug. Pump 6 to 8 full strokes. This will help release any pressurized
air which may be trapped within the reservoir. Check oil level. Proper oil level will vary from just covering the ram
cylinder to 3/16" above it as seen from the oil filler hole. Reinstall oil filler plug.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with authorized
replacement parts only.
Banner Tech. Service (816) 891-6390.
2
Publicité
Table des Matières
