Steam Ironing - Grundig SIS 8250 Mode D'emploi

OPERATION _________________________________
7 After the ironing process is complete, place the
iron onto the storage base.
8 Press and hold down the On/Off switch of
the steam ironing station for a few seconds to
switch the steam ironing station off. Set the tem-
perature control dial to MIN and disconnect
the plug from the power outlet.
– The red power indicator light
blue steam button indicator light LOW
go off.
9
Let the appliance cool down in a location that
is safely out of reach of children.
Filling in the water tank
1
Grab the handle V
and pull the water tank out of the steam iron.
2
Open the lid of the water filling opening
and fill the water tank with tap water or dis-
tilled water up to the MAX marking. The maxi-
mum capacity is 1.7 litres.
3
Close the lid of the water filling opening and
push the water tank completely into the steam
ironing station. Make sure that it clicks into
place properly and is secured to the housing
of the steam ironing station.
Caution
Do not move or shake the steam ironing sta-
7
tion when the water tank is being filled. Water
might spill out from the opening of the water
tank.
4 Press the steam jet button briefly to reset the
iron. After about 10 seconds the iron will be
ready for steam ironing.
Notes
When the water tank is empty, air enters into
7
the pump causing a louder 'pumping' sound.
This is quite normal.
If your tap water is very hard it is recom-
7
mended to mix the tap water with distilled
water on a 50:50 ratio, or use distilled water
only.
24 ENGLISH
N and the
underneath the water tank

Steam ironing

1
Place the appliance on an even, dry and non-
slip surface. The non-slip feet
bility of the appliance.
2 Fill the water tank as described in the section
"Filling in the water tank".
3 Insert the power plug
P
4
Push the On/Off switch
steam ironing station.
– The power indicator
blue steam button indicator light blinks on
LOW P .
5
Adjust the temperature control dial
desired temperature.
– The temperature indicator light
blue. The blue temperature indicator light
F
remains on while the iron is heating up. As
soon as the iron reaches the set temperature,
the temperature indicator light goes off. The
temperature indicator light will go on and
off during usage to indicate that the set tem-
perature is being regulated.
Note
Steam ironing is only possible at higher tem-
7
perature settings between •• and MAX.
6 The water in the water tank heats up within 3
minutes. As soon as the temperature indicator
light goes off and the control indicator in the
steam button remains lit, the steam iron is ready
to use. Hold the iron in horizontal position on
the garments and press the steam jet button
Continue to move the iron when ironing.
Caution
Never direct the steam at people or pets.
7
Notes
When the steam ironing station is switched on
7
it will produce a 'pumping' sound. This is nor-
mal and indicates that water is being pumped
from the water tank into the steam ironing
station.
U ensure the sta-
B into the wall socket.
S to switch on the
N lights up red and the
to the
G
K lights up
H
K
.