KEUCO Royal L1 Instructions D'utilisation page 4

EN
These instructions are for both the installer for instal-
lation and the user for operation and maintenance of
the product. After installation, please hand them over
to the user to keep.
Symbols and explanations
Attention! Warning against bodily injury or damage to
property.
Attention Warning against electric shock.
Attention! Warning against water damage.
Note, tip or reference
Correct installation/test of functionality
Incorrect installation
Observe installation details
Optional/accessories
Switch on/off
Confi rmation tone/click sound
Light regulator (dimmer)
Safety information
– The electrical installation must be performed by a
professional installer pursuant to IEC 60364-7-701/
VDE 0100, Part 701! National and local regulations
must be observed!
– KEUCO strongly recommends that all its bathroom
cabinets containing a 230 V supply should be
protected by an RCD switch with a 30 mA protected
circuit. Our shaver supply unit complies with
BS/EN 61558.
– Do not use the product if it or the power cable is
damaged. Have the manufacturer, customer service
or a similarly qualifi ed person replace it instead.
– It must be ensured that the wall can bear the weight
of the mirror cabinet.
Intended use
Mirror cabinet with dimmable light for use in damp
locations, such as the bathroom or WC.
Product is only suitable for installation indoors!
Attention! Only install in frost-free places.
4
Important information, please read!
Technical specifi cations
Installation dimensions, refer to page 2
Included items, refer to picture 1 on page 12
Connection diagram, refer to picture 2 on page 12
Lighting modes
Installation, refer to picture 3 on page 13
Operation, refer to picture 20 on page 17
For spare parts with order numbers, refer to pages 18
and 19.
Declaration of conformity! This product satisfi es
the requirements of applicable EU directives. The
declaration of conformity for this product can be
obtained at the following address:
KEUCO GmbH & Co. KG, Oesestraße 36,
D-58675 Hemer.
– Supply voltage:
– Max. power consumption:
Prod. No.: Width
13602 1713XX: 650 mm
13603 1713XX: 800 mm
– Protection category:
– Ambient conditions:
Temperature
– Light colour
The product can be operated in two ways.
Operating mode 1 (condition as supplied):
Light on/off on rotary dimmer of the product
(automatically off after power reinstated).
Operating mode 2:
Light on/off on external light switch (automatically on
after power reinstated).
To toggle the operating mode, press and hold the
rotary dimmer 15 seconds while the light is switched
off . The light turns on briefl y to confi rm the change to
the operating mode.
The product has 3 diff erent lighting modes.
Mode 1: Front and wall illumination
Mode 2: Washbasin illumination
Mode 3: Front, wall and washbasin illumination
Press the rotary dimmer for at least one second to
change the lighting modes.
Note: When switching off the lights, the type of
lightning and its intensity are saved and will be the
same after switching on the lights again.
Bulbs may only be replaced by the manufacturer, its
customer service or a similarly qualifi ed person.
For warranty and care information please refer to the
attached warranty and care instructions.
Disposal information! Products with this mark may
not be disposed of in regular household waste, but
rather must be brought to a collection point intended
for this purpose!
230 V AC / 50 Hz
Weight Light
23 kg 24 W
27 kg 26 W
IP20
5° – 40° C
3000 Kelvin