INOVU PEV240 Instructions De Montage page 8

OPERATION (emitter):
C. Remote control of the screen
The emitter which has been successfully programmed can control the receiver's UP/DOWN/STOP function:
−
Press the "UP" button of the remote control and the screen will move upward.
−
Press the "STOP" button of the remote control and the screen will stop.
−
Press the "DOWN" button and the screen will move down.
If the screen is moving upward and you directly press the "DOWN" button, the screen will immediately move down.
D. Battery (remote control)
The emitter is using CR23A battery.
When the battery is low, the LED light will not be on when sending the command, so the command cannot be carried
out.
To change the battery:
· Open the back cover of the battery with a screwdriver
· Take the battery out
· Put in a new battery.
Caution: Please do not dispose the used battery at will.
SPECIFICATIONS
Alimentation
Working temperature (receiver)
Rated load
Emission frequency
Emission duration
Receiver
Transmitting distance
Overheating protection
TROUBLESHOOTING
The LED light of the emitter is off
The LED light of the emitter is on, but the
command cannot be sent
The LED lights of the emitter and receiver
are on, but the motor does not work
There is no feedback
Should there be a problem with this device, please contact INOVU's After-Sales department:
u.com
M. Laurent de la Clergerie, Legal representative of GROUP LDLC, declares that this equipment conforms to the
RED directive 2014/53/UE. The full text of the declaration of conformity can be found at
ldlc.com/
210-240v∽50/60MHZ
-40℃ to +80℃
< 600W AC Power
433 MHZ
8 continuous seconds – it will stop emitting after to save electricity and avoid
interference
Can accept up to 20 remote controllers (single-channel and five-channel)
Open air :80 meters
Through concrete wall: 20 meters
if the receiver mainframe detects the protection of overheated motor, it will disconnect
the relay within 0.75 second automatically to stop the power supply to the motor.
Please check the battery of the emitter.
Please check the connection and the receiver, and/or check the program setting.
Please check the connection and the main power supply of the motor and/or check the
main power supply.
Please check the whether the connection is correct or whether the temperature is above
the prescribed degree.
support@inov-
https://dc.groupe-