Remote Control Setting; Program Setting - INOVU PEV240 Instructions De Montage

REMOTE CONTROL SETTING

PROGRAM SETTING:

A: Remote controller logs on (learns) the receiver
Receiver
Press the "UP"
Then the receiver is waiting to receive the messages according to the codes of the emitter for 10 seconds. The light
will stop flashing after 10 seconds.
Emitter
The program setting button is at the back of the emitter. Press this button by ball pen till the LED light of the receiver
stop flashing.
The coding messages of the single-channel emitter will be stored in the receiver and the receiver will automatically
end its programmed coding mode.
NOTES:
The receiver can only store 20 channels. If trying to input the 21
-
and the LED light of the receiver will stop flashing.
If programming fails according to the above method, it may be that the memory is full, so you will need
-
to delete codes to program a new one.
B: Delete stored channel from the receiver's memory
Receiver
Press the "UP" & "STOP" simultaneously till the LED light is flashing. Then the receiver is waiting to receiver the
deleting location message command of the emitter for 1 minute. The light will stop flashing in 1 minute.
Emitter
Press the "DOWN" button of the emitter till the LED light of the receiver stop flashing. Single-channel emitter's
location message will be deleted from the receiver and the receiver will automatically end its program setting mode.
C：Clear up the recorded messages on the receiver
Press the "UP" & "STOP" simultaneously on the controlling board and the indicator light will be flashing. Keep
pressing the button for 4 seconds and the indicator light will speed up flashing, then leave the finger off the button
and press the "UP" & "STOP" simultaneously again to confirm. Now the log-on remote controller on the controlling
board will be deleted. If there is no repetition of pressing the "UP" & "STOP" simultaneously, this option will be
canceled.
& "STOP" buttons simultaneously till
st
channel, the command will be ignored,
the LED light is flashing.