Reposition The Keyboard Tray - StarTech ARMSTSLG Guide De L'utilisateur

2. Raise the Workstation to the highest position.
3. To adjust the tension of the Workstation, use the large hex key to turn the
adjustment screw clockwise or counterclockwise. (figure 6)
4. To check to see if the tension requires further adjustment, move the Workstation to
the lowest position. Place the equipment back onto the Workstation and do one of
the following:
• If the tension is at the appropriate setting for the weight of the equipment,
move the Workstation to the desired height.
• If you need to adjust the tension further, complete steps 1 to 3 until the
tension is at the appropriate setting for the weight of the equipment.

Reposition the keyboard tray

1. Carefully remove all of the equipment from the Workstation.
2. Raise the Workstation to a position that enables you to access the underside of the
keyboard tray.
3. Use the small hex key to remove the two sets of six screws from the underside of the
keyboard tray. (figure 7)
4. Move the keyboard tray, line up the holes, and insert the two sets of six screws.
5. Use the small hex key to tighten the screws.
figure 6
Instruction manual
Large hex key
Adjustment screw
11