Table des Matières
Publicité
3. Make sure that your equipment is stable on the workstation before you move the
Workstation.
4. Raise the Workstation a short distance. If you can't easily move the Workstation
upwards or it begins to move downwards when you squeeze the paddle, you need
to adjust the tension. For more information about how to do this, see the "Adjust the
tension of the Workstation" section of the manual.
5. Position your equipment cables so that they run through the loops located at the
back of the Workstation. (figure 3)
6. If necessary, reposition the keyboard tray. For more information about how to do
this, see the "Reposition the keyboard tray" section of the manual.
figure 3
Cables
Instruction manual
8
Loop
Publicité
Table des Matières
