Warning Information - Sunex HD 1520 Manuel Du Propriétaire

WARNINg INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of
the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost
or not legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read
to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the
operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical
means, but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel
involved in the use and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the
equipment and its proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured
loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not
designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study and understand all instructions before using. All instructions, warnings and safety precautions must be read and
discussed with an operator in the operator's native language.
• Inspect the ramps before each use. Do not use if damaged, altered, modified, in poor condition, or have loose or
missing hardware or components. Take corrective action before using.
• Do not use the ramps as a foundation for other lifting equipment.
• Do not use beyond rated capacity.
• Do not use ramps with super-single tires. Maximum allowable tread width is 16 inches.
• Use ramps on a hard level surface only.
• Wear eye protection that meets ANSI Z87.1 and OSHA Standards.
• Use ramps only as a matched pair to support one end of a vehicle only. Do not simultaneously support
both ends or one side of a vehicle.
• Do not drive vehicle on ramps until the T-handle is in its stored position.
• Always center each vehicle wheel between the sides of each ramp.
• Do not disconnect vehicle brakes, engine or transmission, drive shaft, universal joints, or wheels when vehicle is on ramps.
• Keep non-skid material under the ramps from slipping by periodic cleaning.
• Failure to heed all instructions, warnings and precautions may result in personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
1520
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
rev. 10/13/10