How To Operate - Nostalgia Electrics Vintage Serie Manuel D'instruction

HOW TO OPERATE

1. First, find a stable surface near an electrical outlet before starting. Make sure the cord
is away from any water source. It is acceptable to use an extension cord if needed.
2. Plug in unit at the OFF position.
3. Turn unit ON position and allow it to run for at least 10 minutes
before adding sugar. This will allow the Extractor Head to heat.
4. Measure level tablespoon of sugar with measuring spoon supplied with your
OLD FASHIONED CARNIVAL COTTON CANDY MAKER. Pour sugar into the
center of the Extractor Head and spin the Extractor Head to level the sugar.
5. Switch to ON position.
6. When you see the cotton candy web begin, collect the cotton
candy on the cone by holding the cone vertically. Rotate the
cone with your fingers while you circle the bowl.
7. Once cotton candy has collected on the cone, hold the cone in a horizontal
position over the Extractor Head while still rotating the cone with your fingers.
Continue turning the cone with your fingers while the cone is in the horizontal
position and move from side to side making sure to collect all the cotton candy.
8. Repeat above steps by adding another measure of sugar into
the Extractor Head and starting again. The cotton candy should
flow more quickly as the unit is sufficiently warm.
9. Never use ingredients other than pure granulated sugar. DO NOT overfill the
Extractor Head. This will cause clogging and unit will not work properly.
10. By following these simple instructions, using your OLD FASHIONED
CARNIVAL COTTON CANDY MAKER will be a fun experience for kids of
all ages and will bring the excitement of a carnival to any occasion.
6