Spray Gun; Types Of Installation - Metal Works VECH1001A Mode D'emploi

®
VECH 1001A-1002A - NLFRENES - v1.0 - 10012014
EN

2 SPRAY GUN

2.1 Description
Your new spray gun is exceptionally rugged in construction and is built to stand up under hard, continuous use. However,
like any other fine precision instruments, its most efficient operation depends on a knowledge of its construction, operation
and maintenance. Properly handled and cared for it will produce beautiful, uniform finishing results long after other spray
guns have worn out.

2.2 Types of installation

2.2.1 Siphon feed cup hookup
Air pressure for atomization is regulated at extractor. Amount of fluid
is adjusted by fluid control screw on gun, viscosity of paint, and air
pressure.
2.2.2 Pressure feed cup hookup
For fine finishing with limited spraying.
Air pressure for atomization is regulated at extractor, fluid pressure at
cup regulator. For heavy fluids and internal mix nozzle spraying, fluid
is adjusted by control screw on gun.
Pressure cup also available less regulator.
2.2.3 Pressure feed tank hookup
For medium production spraying.
(Single regulator)
Air pressure for atomization is regulated at extractor, fluid pressure at
tank regulator.
2.2.4 Pressure feed tank hookup
For portable painting operations.
(Double regulator)
Air pressure for atomization and fluid supply are regulated by two
individual air regulators on tank.
2.2.5 Pressure feed circulating hookup
For heavy production spraying.
Air pressure atomization is regulated at extractor, fluid pressure at fluid
regulator.
12