Chamberlain LiftMaster PROFESSIONAL SECURITY+ Serie Mode D'emploi

Single Button Remote Control
®
For use with 390 MHz Security✚ garage door openers and light controls that have an orange learn
button. The code between the remote control and the receiver changes with each use, randomly
accessing over a billion new codes.
NOTE: Your products may look different than the products illustrated in this manual.
PROGRAMMING THE REMOTE CONTROL
1
TO CONTROL THE GARAGE DOOR OPENER LIGHTS
This feature is only available on garage door openers equipped with a multi-function door control and a remote control with more than one button. Not available with universal receiver.
®
With Security✚ remote controls, a remote control button can be programmed to operate the garage door opener lights without opening the door.
1
With the door closed,
press and hold
the remote
control button
that you want to
control the light.
TO ERASE ALL CODES FROM MEMORY
To deactivate any unwanted remote control, first erase all codes:
1
Mini-Remote Control
3-Button Remote Control
2
Locate the
Smart/Learn
button on
the garage
door opener . .
2
Press and
hold the
+
light button
on the
door control.
Test by pressing the remote control button. The garage door opener lights should turn on or off but the door should not move.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or
play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no
obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to
cross path of moving gate or door.
Press and
immediately release
the learn button.
The learn LED will glow
steadily for 30 seconds.
Within 30 seconds...
3
Press and
hold the
lock button
+
on the
door control.
Press and hold the learn button
on garage door opener until the
learn LED goes out (approximately
6 seconds). All previous codes
are now erased.
Reprogram each remote control you wish to use.
®
SECURITY✚
3
Press and hold the button
on the remote control
that you wish to operate
your door.
REMOTE CONTROLS
Release the
button when the
garage door
opener lights
blink or two
clicks are heard.
After the garage
door opener
lights flash,
release all
buttons.