Pulmic INDUSTRIAL 35 Mode D'emploi page 5

PULMIC INDUSTRIAL 35
CHARACTERISTICS
Pulmic Industrial 35 is a highly efficient sprayer that is suitable for spraying many kinds of chemicals and solutions.
USES: To spray fertilizers, pesticides, cleaning products, etc.
Advantages:
18V lithium-ion battery.
Efficiency: This sprayer can be operated continuously for up to 3 hours and spray more than 76 gallons per battery
charge at a distance of 30 feet.
Never operate the sprayer with strong acids, strong bases or flammable liquids.
TECHNICAL FEATURES
Battery Type LI-ION Autonomy
Battery Voltage 18V Pressure
Battery Capacity 2600 mAh Spray Distance
Battery Charging Time 1 h Tank Capacity
Battery Cycle Life 1000 cycles Flow Rate
Battery Charger 21V/2.5A Pump Life
SETTING-UP
1. Remove the nuts and bolts, holster, and nozzles from liquid intake filter or storage handle.
2. Attach holster and hose holder to tank and tighten with the nuts and bolts.
3. Place nozzles in the holster for easy access.
4. Attach the high pressure spray wand to the spray gun by pulling down on quick-connect collar and inserting
the wand.
5. Snap the wand into the holster and coil the hose around the hose holder until you're ready to spray.
1
4
EN USER'S MANUAL
3 h
70 / 115 (psi)
30 feet
9 gallons
0.4 - 0.6 gal/
min
1000 h
2
3
5
- 8 -
PULMIC INDUSTRIAL 35
STARTING-UP
6. Fully charge the battery prior to first operation.
NOTE: The flashing green light on charger indicates that battery is charging when all lights stop flashing, the
battery is fully charged.
7. Remove the cap and, using the load filter, pour the liquid in the tank. Replace the cap and tighten securely. For
some products, you should prepare before the mixture in a suitable container.
8. Determine which nozzle is right for the job & connect to spray wand by pulling down on quick-connect and
inserting nozzle.
a) Adjustable nozzle: ranges from jet stream to conical stream.
b) Fan nozzle (green): flat 25° stream.
c) Jet nozzle (red): narrow stream.
9. Begin spraying by squeezing spray trigger.
6
8 a) b)
c)
a)
MAINTENANCE
• Rinse out the solution you sprayed with water and spray water through the sprayer for 3-5 minutes to completely
rid the tank of the chemicals.
NOTE: Many spray materials will harden if left in the sprayer and clog the nozzle, or hose. Never use gasoline
to clean out the sprayer.
• Disconnect the hose from the gun and let the hose hang down towards the ground in order to drain the hose of
any liquid.
• Dry sprayer tank and clean the nozzle.
• Store the sprayer in a clean, empty, and shaded location protected from extreme heat or frost.
• For long-term storage, you should remove the battery from the sprayer and store at half load in a dry and stable
temperature (ideal range: 5 ° to 15 ° C), it is also advisable to verify the state of charge at least once every two
months and if charging the battery is required, proceed with recharge depending on future use.
SECURITY CONSIDERATIONS
• While the preparation and application of chemicals, always use appropriate protective equipment.
• Always work in perfect balance on your feet.
• Do not eat, drink or smoke while handling these products and avoid direct contact with skin.
• Read carefully the instructions on the label before using the products.
• For the preparation of the mixtures, use accurate containers.
• After application & working, clean the knapsack & pipes with pure water.
• Wash hands and face and change clothes.
• Observe good agricultural practices, avoiding dealing with wind or elevated temperature. Do not operate
sprayer in temperatures lower than 32°F.
• The sprayer is susceptible to water damage if left in wet conditions.
• Always store it in a cool, dry place.
EN USER'S MANUAL
7
9
c)
- 9 -