Philips SalonStraight XL HP8350/00 Mode D'emploi page 10

EnglisH
10
Note: It is better to section off the crown area and to straighten the hair
underneath first. Then straighten the top area.
8 If the straightening plates are locked, push the locking slide upwards
to unlock them (Fig. 8).
 Take a section that is not wider than 5cm. Place it between the
straightening plates and press the handles of the appliance firmly
together.
10 Slide the straightener down the length of the hair in 5 seconds,
from root to hair end, without stopping to prevent
overheating (Fig. ).
Tip: If you want to create flicks, straighten the lock and turn the
straightener a half-circle inwards (or outwards) when you get to the end of
the lock. Hold the straightener in this position for 2 to 3 seconds and then
release the lock (Fig. 10).
11 Repeat this process after 0 seconds until you have achieved the
desired look.
1 Let your hair cool down. Do not comb or brush it before it has
cooled down, as this would ruin the hairstyle you have just created.
cleaning
Never immerse the appliance in water or any other liquid, nor rinse it
under the tap.
1 Switch off the appliance and unplug it.
 Let the appliance cool down completely on a heat-resistant surface.
 Clean the appliance with a damp cloth.
Note: Make sure the appliance is completely dry before you use or store it.
storage
Never wind the mains cord round the appliance.
1 Switch off the appliance and unplug it.