Alignment Settings - Panasonic TX-28LD90F Instructions De Service

ALIGNMENT SETTINGS:

(The figures below are nominal and used for representative purposes only.)
1. Set the Bass to maximum position, set the Treble to minimum position, press the down button (- / v) on the customer
controls at the front of the TV and at the same time press the INDEX button on the remote control, this will place the TV
into the Service Mode.
2. Press the RED / GREEN buttons to step up / down through the functions.
3. Press the YELLOW / BLUE buttons to alter the function values.
4. Press the STR button after each adjustment has been made to store the required values.
5. To exit the Service Mode, press the "N" button.
Alignment Function
Horizontal Position
Vertical Position
Horizontal Amplitude
Vert. Amplitude
EW-amplitude
EW-amplitude
Trapezium-comp
Horizontal-Parallel
Vertical Linearity
DVCO
Cut-off DC
Highlight
Sub-Brightness
H-Pos
+020
V-Pos
+024
H-Amp
+049
V-Amp
+029
E/W-Amp1
+022
E/W-Amp2
+000
Trapez-1
+033
H-Parallel
+032
V-Lin
+004
DVCO
000
Cut-off
O.K.
High 0031 0031 0031
Sub-Brightness
000
9
Settings / Special features
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Receive a PAL Colour Bar Pattern. For
DVCO alignment press "Blue" button, wait
until the colours are stable and press
"STR".
To adjust Cutoff adjust the screen VR until
the display shows "O.K."
Optimum setting.
Optimum setting.