Thermostat - Gamko MG 000030098 Mode D'emploi

Light on/off
Manual
defrost
Set button
Using the thermostat
For use and settings of the thermostat, please refer to the manual supplied with this product.
Application with XR07CX type thermostat:
To see the set point.
1. Push the SET key two times, the set point will be showed.
2. Push the SET key three times to return to normal visualisation.
To change the set point
1. Push the SET key for more than 2 sec and then push the SET key again;
2. The value of the set point will be displayed and the "°C" LED starts blinking;
3. To change the Set value push the UP or DOWN button;
4. To memorise the new set point value push the SET key three times.
Note: The new set value is fixed even if you leave the settings without the SET button have been pressed.
28

Thermostat

Up/down
button settings