Button Operations - Aqara E1 Manuel De L'utilisateur

7 Remove the protection sheet on the head cover, and install the
head cover back on the device. The installation is complete.
Device Binding & Initialization
1. Before activating the accessory, please make sure you have
the Aqara Home app and the Aqara Zigbee 3.0 hub installed.
2. Please open the app, tap "Home" and then tap "+" in the top
right corner to enter the "Add Device (Accessory)" page. Select
"Roller Shade Driver E1" and the hub to be connected to, and
add it according to instructions in the Aqara Home app. Press
and hold the RESET button for 5 seconds, and wait for the
voice prompt from the Hub.
Device Rotating Range Setup
1. A er the device is connected to the network, you can set the
device rotating range via the Aqara Home app, click the device
card on the homepage of Aqara Home app, and follow the
instructions on the page to set the rotating range;
2. When the device is not connected to the network, the device
rotating range can also be set by pressing the buttons;

Button Operations

Rotating Range Settings
1 Delete rotating range
A er the device is installed, press the Up and Down button at
the same time for 3 seconds until the indicator light turns blue,
and then release it.
5